| Fuel
and propulsion technologies: Increasing
costs of oil-based fuels and tightening environmental laws and restrictions
on greenhouse gas emissions are propelling work on alternative power
systems for automobiles. Efforts to improve or replace these technologies
include hybrid vehicles, electric vehicles and hydrogen vehicles.
Diesel:
Diesel engined cars have long been popular in Europe with the first
models being introduced in the 1930s by Mercedes Benz and Citroen.
The main benefit of Diesels are a 50% fuel burn efficiency compared
with 27%in the best gasoline engines. A down side of the diesel
is the presence in the exhaust gases of fine soot particulates and
manufacturers are now starting to fit filters to remove these. Many
diesel powered cars can also run with little or no modifications
on 100% biodiesel.
Gasoline:
Gasoline engines have the advantage over diesel
in being lighter and able to work at higher rotational speeds and
they are the usual choice for fitting in high performance sports
cars. Continuous development of gasoline engines for over a hundred
years has produced improvements in efficiency and reduced pollution.
The carburetor was used on nearly all road car engines until the
1980s but it was long realised better control of the fuel/air mixture
could be achieved with fuel injection. Indirect fuel injection was
first used in aircraft engines from 1909, in racing car engines
from the 1930s, and road cars from the late 1950s.Gasoline Direct
Injection (GDI) is now starting to appear in production vehicles
such as the 2007 BMW MINI.
Electric:
The first electric cars were built in the late 1800s, but the building
of battery powered vehicles that could rival internal combustion
models had to wait for the introduction of modern semiconductor
controls. Because they can deliver a high torque at low revolutions
electric cars do not require such a complex drive train and transmission
as internal combustion powered cars. Some are able to accelerate
from 0-60 mph (96 km/hour) in 4.0 seconds with a top speed around
130 mph (210 km/h). They have a range of 250 miles (400 km) on the
EPA highway cycle requiring 3-1/2 hours to completely charge. Equivalent
fuel efficiency to internal combustion is not well defined but some
press reports give it at around 135 mpg.
Steam:
Steam power, usually using an oil or gas heated boiler, was also
in use until the 1930s but had the major disadvantage of being unable
to power the car until boiler pressure was available. It has the
advantage of being able to produce very low emissions as the combustion
process can be carefully controlled. Its disadvantages include poor
heat efficiency and extensive requirements for electric auxiliaries.
|